Suse 7.3, sparcstation 20, QLogic scsi adapter
"Christine Desmuke" <[email protected]>
| Newsgroups | gmane.linux.suse.sparc |
|---|---|
| Message-ID | <[email protected]> |
I have recently inherited a SparcStation 20 with no internal hard drive, an external hard drive on a QLogic SBus card, and an internal CD-ROM. When I try to install Suse 7.3 from the cd-rom, it fails to see the hard drive. SunOS 5.6 is currently installed on the external drive and seems to run ok (at least, it boots without error). I want to replace it with Suse, but yast gets as far as probing hardware and reports "Error: no hard disks were found for the installation. Please check your hardware." probe-scsi-all returns: /iommu@f,e0000000/sbus@f,e0001000/QLGC,isp@0,10000 Target 0 Unit 0 Disk Seagate ST410800W .... How do I tell yast where to find the hard drive? Do I need to load a driver for the adapter, and if so, how? Thank you. Christine -- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]