Re: Suse 7.3, sparcstation 20, QLogic scsi adapter
Scott A Micciche <[email protected]>
| Newsgroups | gmane.linux.suse.sparc |
|---|---|
| Message-ID | <[email protected]> |
It seems to be the qlogic driver not hooking so the probe may be successful??? There is clearly a disk there and it must have a disk label on it if SunOS is able to boot.... On Fri, 5 Jul 2002, Christine Desmuke wrote: > Date: Fri, 05 Jul 2002 14:14:28 -0500 > From: Christine Desmuke <[email protected]> > To: [email protected] > Subject: [suse-sparc] Suse 7.3, sparcstation 20, QLogic scsi adapter > > I have recently inherited a SparcStation 20 with no internal hard drive, an external hard drive on a QLogic SBus card, and an internal CD-ROM. When I try to install Suse 7.3 from the cd-rom, it fails to see the hard drive. > > SunOS 5.6 is currently installed on the external drive and seems to run ok (at least, it boots without error). I want to replace it with Suse, but yast gets as far as probing hardware and reports "Error: no hard disks were found for the installation. Please check your hardware." > > probe-scsi-all returns: > /iommu@f,e0000000/sbus@f,e0001000/QLGC,isp@0,10000 > Target 0 > Unit 0 Disk Seagate ST410800W .... > > How do I tell yast where to find the hard drive? Do I need to load a driver for the adapter, and if so, how? > > Thank you. > > Christine > > > > -- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > I firmly believe that any man's finest hour - his greatest fulfillment to all he holds dear... is that moment when he has worked his heart out in a good cause and lies exhausted on the field of battle - victorious.... - Vince Lombardi -- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]