RE : RE : Tao U3 x86_64 new install hangs?

> -----Message d'origine-----
> De : Remco Barendse [mailto:[email protected]] 
> Envoyé : 24 décembre 2004 10:13
> À : Ugo Bellavance
> Cc : Tao-discuss
> Objet : Re: RE : [Tao-discuss] Tao U3 x86_64 new install hangs?
> 
> 
> On Fri, 24 Dec 2004, Ugo Bellavance wrote:
> 
> >
> >
> >> -----Message d'origine-----
> >> De : Remco Barendse [mailto:[email protected]]
> >> Envoyé : 24 décembre 2004 10:02
> >> À : Tao-discuss
> >> Objet : [Tao-discuss] Tao U3 x86_64 new install hangs?
> >>
> >>
> >> Hi list!
> >>
> >> I am trying to install Tao x86_64 U3 on a new box with an MSI K8N 
> >> Neo2 motherboard (which has nForce 3 chipset).
> >>
> >> The x86 version of Tao boots all the way up to the 
> graphical install 
> >> screen (but not further because I want to install it on a 
> 3Ware 9500 
> >> controller for which the driver is missing in x86).
> >>
> >> The x86_64 version however hangs during the initial boot up (even 
> >> before the welcome screen appears). The system hangs immediately 
> >> after the presence of the two PATA controllers is 
> reported. The x86 
> >> version immediately reports the PATA devices it finds, the x86_64
> >> version hangs
> >> before it can report any devices.
> >
> > Did you verify the MD5?
> > Did you check the media?
> 
> No but I am using the same DVD that I used for the 
> installation of the box 
> with the HDAMA. It's not impossible but not very likely 
> either that the 
> media has gone bad that quick.

And did you test the DVD before instaling on the HDAMA?

Anyways... You know where I'me leading, better test the media on the new server as well...
> 
> I suspect a problem with the ide driver in the kernel of U3 x86_64.
>