Re: Tao 4 Pre Beta ?

Hi Marc,

> 1- Im installing it into a VMWare GSX Session, and by default it use 
> SCSI disk, and it seem the installer haven't detected it.  So I decided 
> to use IDE drive for the moment.

Not too worried about that just yet.

> 2- On the first boot, I had a Redhat Logo (with a count down of a few 
> seconds)

Known, fixable.

> 3-smartd failled at first boot(probably normal for the RHEL4 too)

I see this a lot, probably not an issue.

> 4-/etc/yum.conf have RH stuff in it, Ive put the correct informations in 
> it manually (BTW, YUM IS FAST NOW !!! WOOHOO hehe, not as fast as 
> apt-get but still better)
> 5-default HTML page for httpd contain Red Hat text

Yes - there are a lot more reasons I didn't announce this as even a beta
yet. ;-)

> 6-kernel source package is missing ???

Doesn't exist anymore!  The official way to build a kernel now is using
the src.rpm; supposedly it's in the official RH release notes.
> 
> I mean, it about all I see so far, I'll play with it more, but install 
> was smooth, except this yum.conf I had to change, everything work fine I 
> think.  YOU ROCK.
> I'll keep you posted if I see anything else

Ok, and thanks for checking it out.  If you have the time/energy, mind
setting up a local DHCP server with it and see if it works?  see:
http://mailman.taolinux.org/pipermail/tao-discuss/2005-March/000896.html

regards,
	David
> 
> Marc O. Chouinard
> 
> 
> _______________________________________________
> Tao-discuss mailing list
> [email protected]
> http://mailman.taolinux.org/mailman/listinfo/tao-discuss

_______________________________________________
Tao-discuss mailing list
[email protected]
http://mailman.taolinux.org/mailman/listinfo/tao-discuss

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)

iD8DBQBCLGgz4J4WoZuSf3URAtWSAKCosy89U8Jg7edO1pPbvfO72E8WiACfTNJm
8pIzoyfIW9DgpWb6DolcJ+s=
=MG97
-----END PGP SIGNATURE-----