"man vi" changes charset in 2.0.x
Greg Kagel <[email protected]>
| Newsgroups | gmane.linux.tomsrtbt |
|---|---|
| Message-ID | <[email protected]> |
Have run into the weirdest problem with the 2.0.x tomsrtbt. When I tried "man vi" on 2.0.0, it printed half a line of gibberish, which then trailed down the middle of the screen. The pager was working, as it showed the percentage of the file viewed. I did a PGDN till I got to the end of the file, and by then the output was apparently a non-ASCII characterset, remeniscent of the old Commadore Pet block graphics. Other releases I've tried since -- .9, .16, and now .20 -- all do the same thing. I don't believe this happened prior to 2.0.x. Nothing strange about my setup: Abit KT7A motherboard Athlon Thunderbird 1.2GHz VisionTek GeoForce 2 GTS video card Philips 107S monitor Anybody else seen this kind of weirdness? -- Greg Kagel [email protected]