Re: 3c575 ifconfig oops / segmentation fault with 2.0.85

Tom Oehser <[email protected]>
Newsgroups gmane.linux.tomsrtbt
Message-ID <[email protected]>
I have not used or tried 3c575.  What I can do is try rebuilding the
pcmcia stuff, the kernel has been rebuild since I built the pcmcia
stuff which could have broken something (though probably not).  Try
looking for a newer one in a couple of days.  It may be also you need
cardbus.o in addition to cb_enabler.o?  Try that too. -Tom

On Sun, 28 Apr 2002, Fabrice LABORIE wrote:

> Date: Sun, 28 Apr 2002 19:21:17 +0300
> From: Fabrice LABORIE <[email protected]>
> To: [email protected]
> Subject: [tomsrtbt] 3c575 ifconfig oops / segmentation fault with 2.0.85
>
> Hi !
>
> I am having some problems here with a ThinkPad 600E with a 3com 3c575 card
> (3CCFE575CT)
>
> I found the
> v2-add-ons/pcmcia/3c575_cb.o.bz2 and
> v2-add-ons/pcmcia/cb_enabler.o.bz2
> modules ...
>
> I changed the pcmcia/config  so to get the card recognized.
>
> 1)
> whenever I was inserting the card, I was getting an error
> (kernel: Unable to handle kernel paging request at virtual address...
> + oops !)
>
> I had to remove the "dhcp--" from the ./network script.
> the error went away...
>
> 2) if I try to configure the card manually , I still get an "oops"
> as soon as I use a "ifconfig eth0 xx.xx.xx.xx"
> "I still get an Unable to handle kernel paging request ...."  :(
>
> I am stuck....
>
> I looked on the list archive but I find an related matter... Anybody has
> seen this ?
>
>
> Ok .. maybe I am doing something wrong ... because after spending some time
> looking
> around, it seems that the 3c575_cb.o is actually loading a 3c59x  driver but
> older
> than the one that comes with built-in with the kernel ...
> (in kernel I think there is 3x59x.c 18Feb01 , where as the 3c575_cb module
> seems to be 3x59x.c:0.99Q 5/16/2000 )
>
> Has Anyone built a 3c575_cb.o from a more recent 3x59x.c file ???
>
> Or should I try to use the kernel built-in driver?? ( I read the manual
> of pcmcia but I didn't see how to bind to a buil-in kernel driver instead of
> a module ??)
>
>
> as always,
> any help is appreciated !
>
> fab
>
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.