Problem with PLIP in 2.0.85?

	Downloaded 2.0.85 this morning and found that if my HP Deskjet 600C is on 
during boot, it begins to cycle and I have to restart it to use. 
Haven't had this problem with earlier versions of tomsrtbt or any other 
OS.  The latest I had before .85 was either a .2x or .3x (overwrote the 
floppy with .85 and thus can't really check).

	Dmesg during the printer reaction is:

hda: WDC WD400BB-00CFC0, ATA DISK drive
hdc: LITE-ON LTR-24102B, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: WDC WD400BB-00CFC0, 38166MB w/2048kB Cache, CHS=4865/255/63
hdc: ATAPI 40X CD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
ppa: Version 2.07 (for Linux 2.2.x)
WARNING - no ppa compatible devices found.
   As of 31/Aug/1998 Iomega started shipping parallel
   port ZIP drives with a different interface which is
   supported by the imm (ZIP Plus) driver. If the
   cable is marked with "AutoDetect", this is what has
   happened.
imm: Version 2.03 (for Linux 2.0.0)
scsi : 0 hosts.
scsi : detected total.
NET3 PLIP version 2.3-parport [email protected]
plip0: Parallel port at 0x378, using IRQ 7
early initialization of device plip0 is deferred
SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256).
3c59x.c 18Feb01 Donald Becker and others 
http://www.scyld.com/network/vortex.html
pcnet32.c: PCI bios is present, checking for devices...

	(I'm sure it's just the last few lines, but this what scrolls by when the 
printer reacts.)

-- 
Greg Kagel
[email protected]