Re: Game Boy Advance expansion card
"Scott Christensen" <[email protected]>
| Newsgroups | gmane.linux.uclinux.actiontec |
|---|---|
| Message-ID | <[email protected]> |
>Does this Xilinx stuff contain FPGA code written in Verilog or something? Not sure. Here is a pointer to the free tool they provide: http://www.xilinx.com/ise/wp_overview.pdf >And if anyone is yet unfamiliar with FPGAs and what they can do, I found a >great article covering the basics covering the basics at Kuro5hin: > > http://www.kuro5hin.org/story/2004/2/27/213254/152 The company "Digilent" mentioned in this article has a $15 circuitboard that converts a surface mount CPLD (CoolRunner II - XC2C256) to a 40 pin DIP. This was advertized in electronic mag, but I can not find it on Digilent's website. I've sent them an email asking about it. This sounds promising for cheap and easy to prototype. Also, another site mentioned is opencores.com and it has lots of free modules (processors, uarts, USB interfaces, etc). Ya'all that want a USB interface should check this site out. _________________________________________________________________ Get fast, reliable access with MSN 9 Dial-up. Click here for Special Offer! http://click.atdmt.com/AVE/go/onm00200361ave/direct/01/ __ ActionHack Mailing List - ActionHack-W7/[email protected] http://www.express.org/mailman/listinfo/actionhack http://www.embeddedlinuxinterfacing.com/wiki.php/ActiontecDualModem