Re: Status of "Home Grown" ActionTec Development Daughterboard

Bruce D. Lightner wrote:
>The other is with the crystal can, which really needs to be mounted on the
>bottom of the PCB (or a couple of millimeters needs to be taken out of the
>top of the case).  The crystal can easily be moved to the bottom of the
>PCB, but it will need to be insulated (e.g., shrink tubing).

How about shifting the USB/serial header half an inch further inboard and 
squeezing in the crystal here?  Alternatively, you could make the board a 
"U" shape (which you probably need to do anyway, to accommodate the 
standard serial and USB connectors) and plop the crystal on the other side 
of those two big caps?

And another suggestion: there are 3 open LED pads on the 
motherboard.  There's always a need for more blinkenlights. :-)

--
Scott Nicol
[email protected] 

__
ActionHack Mailing List - ActionHack-W7/[email protected]
http://www.express.org/mailman/listinfo/actionhack
http://www.embeddedlinuxinterfacing.com/wiki.php/ActiontecDualModem