Re: __stack_start for ColdFire uClinux
Greg Ungerer <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi Larry, On 09/27/2012 10:08 AM, Larry Baker wrote: > I hacked the .s file for my stack check test program. I haven't had a minute to look over the code yet. Will get back to you on that. [snip] > There must be code between __stack_start and the initial stack pointer. Yes? No code in that region. Possibly data, though typically not. > binfmt_flat.c knows all? By the way, where is binfmt_flat.c? That is the kernel's FLAT file loader. See linux/fs/binfmt_flat.c Regards Greg ------------------------------------------------------------------------ Greg Ungerer -- Principal Engineer EMAIL: [email protected] SnapGear Group, McAfee PHONE: +61 7 3435 2888 8 Gardner Close, FAX: +61 7 3891 3630 Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev