QEMU and ColdFire
Greg Ungerer <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi All, It seems QEMU has support for ColdFire, has anyone here been using it? It seems it is a little broken when trying to run the very most recent linux kernels. Here are some patches that will fix that: http://lists.nongnu.org/archive/html/qemu-devel/2012-09/msg01954.html http://lists.nongnu.org/archive/html/qemu-devel/2012-09/msg02099.html http://lists.nongnu.org/archive/html/qemu-devel/2012-09/msg01956.html Those patches applied to the latest qemu git tree, though I suspect they should apply to v1.2 qemu source without too much trouble. Then you can emulate a ColdFire M5208EVB board and run current kernels on it. I have been running linux-3.5 kernels. If you don't want to start up with gdb support then you need to generate a kernel object that contains an initrd (which is not normally generated by the uClinux-dist build system). With that you then simply run it with: qemu-system-m68k -nographic -machine mcf5208evb -kernel vmlinux Could be kinda useful. Regards Greg ------------------------------------------------------------------------ Greg Ungerer -- Principal Engineer EMAIL: [email protected] SnapGear Group, McAfee PHONE: +61 7 3435 2888 8 Gardner Close FAX: +61 7 3217 5323 Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev