Problems with a dongle sis163u and USB ports

Thibaud Hulin <[email protected]>
Newsgroups gmane.linux.usb.devel
Message-ID <[email protected]>
Hi !

I'm trying to use a dongle for ndiswrapper, but it fails because a 
problem of usb. Note that the problem appear when ndiswrapper is fully 
uninstalled (and others packages as ndiswrapper-utils, with modprobe -r, 
etc...).

So ; when I get on the first time the dongle, a lsusb give :
Bus 001 Device 002: ID 0457:0163 Silicon Integrated Systems Corps.
Bus 001 Device 001: ID 0000:0000
But, a few seconds later, the dongle is not recognize with sometimes an 
error -71.
Then, lsusb forget the driver and get :
Bus 001 Device 001: ID 0000:0000

How can I configure the kernel to have the good configuration ? I tried 
different ways, but it fails.

I already reinstalled the bios.

See at below for the result of these commands (when I try the dongle) :
"lspci -v |grep HCI"
"cat /var/log/messages" (the end)
"dmesg |grep usb"

Thanks for help,
Thibaud.

NB1 : thanks to Alex Davis and Oliver Neukum for advices and 
recommendations about check if the problem was from ndiswrapper or not. 
I hope there is not a special list for kernel USB ; if yes : apologizes, 
I couldn't find it.

NB2 : I'm not sure if this message is too long or not. I included the 
mention "End of the message" at last.

---------------

My hardware :
Computer : dell pentium mmx 233 mst
ram : 128 Mo
dongle : thomson WLG-1500A - chipset Sis163u
Kernel 2.6.19
Ubuntu Edgy

"lspci -v |grep HCI" :

00:01.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 
01) (prog-if 00 [UHCI])

-------------

"cat /var/log/messages"

Feb 11 21:41:08 localhost kernel: [ 6049.104000] usb 1-1: new full speed 
USB device using uhci_hcd and address 2
Feb 11 21:41:08 localhost kernel: [ 6049.252000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:12 localhost kernel: [ 6053.592000] usb 1-1: USB 
disconnect, address 2
Feb 11 21:41:12 localhost kernel: [ 6053.712000] usb 1-1: new full speed 
USB device using uhci_hcd and address 3
Feb 11 21:41:13 localhost kernel: [ 6053.860000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:15 localhost kernel: [ 6056.592000] usb 1-1: USB 
disconnect, address 3
Feb 11 21:41:15 localhost kernel: [ 6056.712000] usb 1-1: new full speed 
USB device using uhci_hcd and address 4
Feb 11 21:41:16 localhost kernel: [ 6056.856000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:19 localhost kernel: [ 6059.700000] usb 1-1: USB 
disconnect, address 4
Feb 11 21:41:19 localhost kernel: [ 6059.812000] usb 1-1: new full speed 
USB device using uhci_hcd and address 5
Feb 11 21:41:20 localhost kernel: [ 6059.960000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:20 localhost kernel: [ 6060.204000] usb 1-1: USB 
disconnect, address 5
Feb 11 21:41:20 localhost kernel: [ 6060.316000] usb 1-1: new full speed 
USB device using uhci_hcd and address 6
Feb 11 21:41:20 localhost kernel: [ 6060.464000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:21 localhost kernel: [ 6062.220000] usb 1-1: USB 
disconnect, address 6
Feb 11 21:41:21 localhost kernel: [ 6062.332000] usb 1-1: new full speed 
USB device using uhci_hcd and address 7
Feb 11 21:41:21 localhost kernel: [ 6062.480000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:22 localhost kernel: [ 6062.724000] usb 1-1: USB 
disconnect, address 7
Feb 11 21:41:22 localhost kernel: [ 6062.836000] usb 1-1: new full speed 
USB device using uhci_hcd and address 8
Feb 11 21:41:22 localhost kernel: [ 6062.984000] usb 1-1: configuration 
#1 chosen from 1 choice
Feb 11 21:41:22 localhost kernel: [ 6063.480000] usb 1-1: USB 
disconnect, address 8
Feb 11 21:41:22 localhost kernel: [ 6063.592000] usb 1-1: new full speed 
USB device using uhci_hcd and address 9
Feb 11 21:41:24 localhost kernel: [ 6064.452000] usb 1-1: new full speed 
USB device using uhci_hcd and address 10
Feb 11 21:41:24 localhost kernel: [ 6065.012000] usb 1-1: new full speed 
USB device using uhci_hcd and address 11
Feb 11 21:41:24 localhost kernel: [ 6065.532000] usb 1-1: new full speed 
USB device using uhci_hcd and address 12


-------------

dmesg |grep usb :

[   17.780000] usbcore: registered new interface driver usbfs
[   17.784000] usbcore: registered new interface driver hub
[   17.788000] usbcore: registered new device driver usb
[   17.808000] usb usb1: configuration #1 chosen from 1 choice
[   69.416000] usbcore: registered new interface driver ndiswrapper
[ 5916.300000] usbcore: deregistering interface driver ndiswrapper
[ 6049.104000] usb 1-1: new full speed USB device using uhci_hcd and 
address 2
[ 6049.252000] usb 1-1: configuration #1 chosen from 1 choice
[ 6053.592000] usb 1-1: USB disconnect, address 2
[ 6053.712000] usb 1-1: new full speed USB device using uhci_hcd and 
address 3
[ 6053.860000] usb 1-1: configuration #1 chosen from 1 choice
[ 6056.592000] usb 1-1: USB disconnect, address 3
[ 6056.712000] usb 1-1: new full speed USB device using uhci_hcd and 
address 4
[ 6056.856000] usb 1-1: configuration #1 chosen from 1 choice
[ 6059.700000] usb 1-1: USB disconnect, address 4
[ 6059.812000] usb 1-1: new full speed USB device using uhci_hcd and 
address 5
[ 6059.960000] usb 1-1: configuration #1 chosen from 1 choice
[ 6060.204000] usb 1-1: USB disconnect, address 5
[ 6060.316000] usb 1-1: new full speed USB device using uhci_hcd and 
address 6
[ 6060.464000] usb 1-1: configuration #1 chosen from 1 choice
[ 6062.220000] usb 1-1: USB disconnect, address 6
[ 6062.332000] usb 1-1: new full speed USB device using uhci_hcd and 
address 7
[ 6062.480000] usb 1-1: configuration #1 chosen from 1 choice
[ 6062.724000] usb 1-1: USB disconnect, address 7
[ 6062.836000] usb 1-1: new full speed USB device using uhci_hcd and 
address 8
[ 6062.984000] usb 1-1: configuration #1 chosen from 1 choice
[ 6063.480000] usb 1-1: USB disconnect, address 8
[ 6063.592000] usb 1-1: new full speed USB device using uhci_hcd and 
address 9
[ 6063.712000] usb 1-1: device descriptor read/64, error -71
[ 6064.340000] usb 1-1: device not accepting address 9, error -71
[ 6064.452000] usb 1-1: new full speed USB device using uhci_hcd and 
address 10
[ 6064.572000] usb 1-1: device descriptor read/64, error -71
[ 6064.796000] usb 1-1: device descriptor read/64, error -71
[ 6065.012000] usb 1-1: new full speed USB device using uhci_hcd and 
address 11
[ 6065.420000] usb 1-1: device not accepting address 11, error -71
[ 6065.532000] usb 1-1: new full speed USB device using uhci_hcd and 
address 12
[ 6065.940000] usb 1-1: device not accepting address 12, error -71

----------------

End of the message

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/




-------------------------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier.
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.