Re: [WBEL-users] x not starting

Hi Terry,

We seem have a number of old messages today.

Thanks for you help with this, I managed to recover the key directories, 
then wiped the server and started again, so all sorted.

I used the ide drive to get the server running, then added the scsi back in, 
then fixed the disk.  Backed up the key data, then removed the ide, 
re-installed the scsi disk, then re-load the o/s.

Best wishes

Jim

----- Original Message ----- 
From: "Terry Henderson" <[email protected]>
To: "whitebox-users" <[email protected]>
Sent: Tuesday, July 18, 2006 9:55 PM
Subject: Re: [WBEL-users] x not starting


> On 7/18/06, Multisys, Jim Keable <[email protected]> wrote:
>> Hi Terry,
>>
>> Sorry for my typing mistakes, I'm running KDE, was using df -h.
>>
>> The is running KDE as an easier interface for the end-user/admin.
>>
>> I have run fcsk and now my drive appears to be wiped:-
>>
>> Bad magic number in super-block while trying to re-open
>> e2fsck:- io manger magic bad.
>>
>> Any ideas, I think I'm screwed, was hoping to get the partition working 
>> and
>> off-load the data if that is possible.
>>
>> Was going to install an ide disk, load whitebox, then try adding the SCSI
>> drive to it, what do you think?
>>
>
> That would be fine. No reason not to have a SCSI drive.
> Did fsck report any specific problems?
>
>
>> Thanks
>>
>> Jim
>>
>>
>> ----- Original Message -----
>> From: "Terry Henderson" <[email protected]>
>> To: "whitebox-users" <[email protected]>
>> Sent: Tuesday, July 18, 2006 6:58 AM
>> Subject: Re: [WBEL-users] x not starting
>>
>>
>> > What happens when fsck is run?
>> >
>> > On 7/17/06, Multisys, Jim Keable <[email protected]> wrote:
>> >>
>> >>
>> >> A customer filled the hard disk on one of our whitebox 3 respin 2
>> >> servers.
>> >>
>> >> Although I deleted several gb's of data however the dr -h still 
>> >> reports
>> >> 100%
>> >> full.
>> >
>> > You mean "df -h" ?
>> >
>> >
>> >>
>> >> Also KBE no longer loads, it keeps restarting over and over from the 
>> >> text
>> >> login prompt, this started after the above.
>> >
>> > You mean  kde ?
>> >
>> >    What kind of server is it?  Why does it have X on it?
>> > I think you need to tell us a little more about this system, give us a
>> > few more details about it. What filesystem is it? etc.
>> >
>> >
>> >>
>> >> I would rather not have to re-load the server, can any one give me any
>> >> pointers in re-covering from this.
>> >>
>> >> Thanks
>> >
>> >
>> >>
>> >> Jim
>> >> _______________________________________________
>> >> Whitebox-users mailing list
>> >> [email protected]
>> >> http://beau.org/mailman/listinfo/whitebox-users
>> >>
>> >>
>> >>
>> > _______________________________________________
>> > Whitebox-users mailing list
>> > [email protected]
>> > http://beau.org/mailman/listinfo/whitebox-users
>> >
>>
>>
>
>
> -- 
> Registered Linux User 188099
>                  <><
> _______________________________________________
> Whitebox-users mailing list
> [email protected]
> http://beau.org/mailman/listinfo/whitebox-users
>