Re: [WBEL-users] connect to internet

> At Thu, 30 Oct 2008 10:16:20 -0700 (PDT) [email protected] wrote:
> 
>> here is the kicker
>> did a /sbin/lspci
>> result list was
>> etc0: Broadcom corperation BCM440 110/100 Mbps PCI(rev 02)
>> modem: Broadcom corperation BCM4212 v.90 56k modem (rev 02)

Check this:

http://www.linuxquestions.org/questions/slackware-14/installing-modem-broadcom-corporation-bcm4212-449422/

Someone else has the same modem:

------
I need help setting up my modem. I have a driver that might work 
BCMSM-3.4.19-6.i386.rpm

/sbin/lspci -vv
02:01.0 Modem: Broadcom Corporation BCM4212 v.90 56k modem (rev 02) 
(prog-if 00 [Generic])
Subsystem: Dell: Unknown device 0002
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort+ <TAbort- 
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 5
Region 0: Memory at fcffa000 (32-bit, non-prefetchable) [size=4K]
Region 1: I/O ports at df30 [size=16]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=55mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
------

-- Mike B.