Fw: Authentication

I do not see this message posted, though I did receive it as a pending message awaiting authorization to be posted to the group.

If the username and password are stored in the registry, then Blat will use those stored values automatically without you needing to specify them on the normal command line.

Chip


From: [email protected] 
Sent: Saturday, November 28, 2015 3:54 AM
To: [email protected] 
Subject: Authentication

I am new to using 'Blat' so please bear with me.


Question:-  As you can store username/password in the registry, can you pick up these values within a ‘blat’ command line statement other than use (–u <value>  –pw <value>) when outgoing server requires authentication?

Syntax examples would be most useful in using 'Blat'  Do they exist?

Many thanks Geoff