Re: spf problems]

You don't mention which OS this is on, but I have a few suggestions.  IIRC
I had to make sure the compile could find the spf library.  It's installed in
/usr/local/lib on my box.  In linux you need to make sure that path is in
/etc/ld.so.conf and then run ldconfig.  On Solaris, make sure you add the -L
and -R flags to, I believe EXTRALIBS, in Local/Makefile.  After a make it
should find the library and then work. :)

Thanks,
mikeS

----- Forwarded message from andy <[email protected]> -----
Hi, Ive just compiled spf into exiscan and it cant find the "fail" part.

  deny message = $sender_host_address is not allowed to send mail from $sender_address_domain
          spf = fail



[root@ns2 exim]# /usr/local/etc/rc.d/exim.sh restart
Stopping exim.
Starting exim.
2004-06-22 13:15:48 Exim configuration error in line 280 of /usr/local/etc/exim/configure:
  error in ACL: unknown ACL condition/modifier in "spf = fail"



is there any way to check that its been compiled in ok, Ive followed the instructions carefully and recompiled a few times going over everything.

cheers
----- End forwarded message -----

-- 
Michael Sprague  | [email protected]
Partner          | System and Network Engineering (SaNE), LLC
use STD::disclaimer;