Re: Forwaring mail with sendmail. Was: Which

You are where I am this morning :-)

The forwarding works, now to put in the greylist stuff.


Question to all:

I have the 4.2 CentOS with (it appears) Milter supposed compiled in sendmail 
and multi-threaded support in Perl.

It looks like I still have to d/l and install the Perl sendmail::milter 
code, DBI, and DBD code - but I can skip the steps of having to re-build 
sendmail and re-build Perl?

Thanks,
Dennis

===== Original Message from [email protected] (Greylisting 
Users and Developers Discuss) at 2/07/06 8:30 pm
>Thanks, that worked.  FYI, this is a clean install of CentOS 4.2 with
>Sendmail 8.13.1.  For those doing the same, you'll need to add the
>domain to /etc/mail/access
>
>Now to get Sendmail::Milter to install. I must be forgetting something
>because I get this:
>
>
>  CPAN.pm: Going to build C/CY/CYING/Sendmail-Milter-0.18.tar.gz
>
>Usage: perl Makefile.PL <path-to-sendmail-source> <path-to-sendmail-obj.dir>
>(e.g. 'perl Makefile.PL ../sendmail
>../sendmail/obj.FreeBSD.4.0-RELEASE.i386')
>
>make: *** No targets specified and no makefile found.  Stop.
>  /usr/bin/make  -- NOT OK
>Running make test
>  Can't test without successful make
>Running make install
>  make had returned bad status, install seems impossible
>
>
>
>On 2/7/06, Dennis Wynne <[email protected]> wrote:
>
>> You MAY need to add
>>
>> gtlogistics.com RELAY
>>
>> to the access table as well.  Again, restart sendmail and make sure the
>> access.db time is newer than the file time (or the same).
>
>_______________________________________________
>Greylist-users mailing list
>[email protected]
>http://lists.puremagic.com/cgi-bin/mailman/listinfo/greylist-users