Testing SRS

Dear List

I am about to implement SPF - so far short periods of testing when the 
mail traffic is low seem to be OK .

I was hoping you could point me to a document that has the procedures 
to undertake a full test of SPF and SRS before I make the system live. 
End users are very touchy about loosing emails.

Thanks in advance
Stephen Carr

-- 
Computing Officer
School of Civil and Environmental Engineering
The University of Adelaide
Adelaide, South Australia,
Australia 5005
Phone +618 8303-4313
Fax   +618 8303-4359
Email [email protected]

CRICOS Provider Number 00123M
----------------------------------------------------------- 
This email message is intended only for the addressee(s) 
and contains information that may be confidential and/or 
copyright.  If you are not the intended recipient please notify 
the sender by reply email and immediately delete this email. 
Use, disclosure or reproduction of this email by anyone other 
than the intended recipient(s) is strictly prohibited. No representation 
is made that this email or any attachments are free of viruses. 
Virus scanning is recommended and is the responsibility of the 
recipient.