RE: Installation problems

"Mike Burkhouse" <[email protected]>
Newsgroups gmane.mail.sqwebmail
Organization The Consultants Network
Message-ID <009201c3f642$5206aef0$1401000a@MIKEB>
> -----Original Message-----
> From: Rick van Vliet [mailto:[email protected]] 
> Sent: Wednesday, February 18, 2004 9:47 AM
> To: [email protected]
> Subject: Re: [sqwebmail] Installation problems
> 
> 
> On Wed, 18 Feb 2004 09:12:08 -0500, Mike Burkhouse 
> <[email protected]> wrote:
> 
> > Hi All,
> >
> > I have a new installation of sqwebmail that I am working with and I 
> > need some help.  Here are some system details:
> >
> > RHEL 3
> > Netqmail 1.04
> > Apache 2.0.48 installed to /usr/local/apache2/
> > Sqwebmail 3.6.2
> >
> > I installed sqwebmail with the following options:
> >
> > Configure --enable-cgibindir=/usr/local/apache2/cgi-bin
> > --enable-imagedir=/usr/local/apache2/icons
> > Make configure-check
> > make
> > Make check
> > Make install-strip
> > Make install-configure
> >
> > All installation steps seem to run without error.
> >
> > When I try to browse to http://localhost/cgi-bin/sqwebmail 
> , I get the 
> > following error:
> >
> > Internal Error
> >
> > The webmail system is temporarily unavailable.  An error 
> occurred in 
> > function write: Transport endpoint is not connected.
> >
> > So I have a couple of questions:
> >
> > 1) Can anyone help with this?
> > 2) Is there an archive for this list that I can browse?
> >
> > Regards,
> >
> > Mike
> >
> >
> 
> Hi Mike,
> Dumb questions, but:
> 1)Can you browse any other pages being served on 
> //localhost/? 2)Have you looked at permissions in that/those folders
> 2a) Is that a standard CGI path for Apache2? (I forget)
> 3) Can you hit the page using //"domainname"/cgi-bin/sqwebmail ?
> 4) have you searched the archives? 
> http://www.mail-archive.com/[email protected]/
> 
> Just some things to try.
> Rick
> 

Thanks for your reply, Rick.  I got past the original issue - sqwebmaild had
shut down while I wasn't looking.  I was able to access the login page once
I started it back up again.

Now on to bigger and more confusing things...

When I enter my valid username and password, I get a big ugly error message
that says: 

Internal error (module maildir.c, line 170) - contact system administrator

I did a reinstall of sqwebmail to no avail.  I searched the archives for a
bit and everything I read said that this error was fixed. 

Can anyone lend a hand?

Thanks,

Mike
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.