Re: Maia Guard and Freebsd 12. Problems with PHP..ini
Jason Hirsh <[email protected]>
| Newsgroups | gmane.mail.virus.maiamailguard |
|---|---|
| Message-ID | <[email protected]> |
i built following the purple hat tutorial which was painful but i got it going until i did a recent port update per a earlier suggestion i deinstalled Smarty 3 and went back to Smarty 2 this may be part of my problem as my symbolic link is to smarty 3 as you set forth here jason > On Apr 22, 2020, at 11:43 AM, jjs - mainphrame <[email protected]> wrote: > > > Keep in mind that it's case sensitive. "smarty" != "Smarty" > > Jake > >> On Wed, Apr 22, 2020 at 8:40 AM Jason Hirsh <[email protected]> wrote: >> Jake >> >> Path to that on my server is "/usr/local/share/smarty/Smarty.class.php" >> >> So I should have that covered unless the following is wrong >> >> include_path = "/usr/local/share/pear:/usr/local/share/smarty" >> >> Thank again >> >> >> Jason >> >> >> >>> On Apr 22, 2020, at 10:44 AM, jjs - mainphrame <[email protected]> wrote: >>> >>> Remember, it's looking specifically for "Smarty/Smarty.class.php" (case sensitive) >>> >>> Jake >>> >>>> On Wed, Apr 22, 2020 at 5:50 AM Jason Hirsh <[email protected]> wrote: >>>> Ok. New day tried again >>>> >>>> Removed smarty 3 and installed smarty 2 which installed under /usr/local/share/smarty >>>> >>>> Using include_path = "/usr/local/share/pear:/usr/local/share/smarty" >>>> >>>> Pear is loaded happy but no smarty according to the configtest.pl >>>> >>>> Can’t get any access to Smarty Mailing list or Forum >>>> >>>> Took me a month to get Maia installed originally now its dead after a simple upgrade >>>> >>>> >>>> Jason >>>> >>>> >>>> >>>>> >>>>> In general, I find that Smarty3 breaks maia, and I've always had to install Smarty2 to get a 100% working setup. >>>>> >>>>> I've always installed Smarty under /usr/share/php. Do you have a single php.ini for cli and web versions? >>>>> >>>>> Jake >>>>> >>>>>> On Tue, Apr 21, 2020 at 2:37 PM Jason Hirsh <[email protected]> wrote: >>>>>> And SmartI recently upgraded my Server running Freebsd 12.1 1. PHP. 7.2.29 PEAR 1.10.6 and smarty3-php72-3.1.32 >>>>>> >>>>>> >>>>>> My Configuration tester says that all is OK except for smarty. I think I am messing up the php.ini. include_path >>>>>> >>>>>> >>>>>> My current is >>>>>> >>>>>> include_path = "/usr/local/share/pear:/usr/local/share/smarty3-php72” >>>>>> >>>>>> The Maia config test is happy except for Smarty. Where it says “Failed Not Installed”. The reference page has been no help >>>>>> >>>>>> Any suggestions?? >>>>>> >>>>>> Jason >>>>>> _______________________________________________ >>>>>> Maia-users mailing list >>>>>> [email protected] >>>>>> http://www.renaissoft.com/cgi-bin/mailman/listinfo/maia-users >>>> >> _______________________________________________ Maia-users mailing list [email protected] http://www.renaissoft.com/cgi-bin/mailman/listinfo/maia-users