Re: The new glibc in RedHat 9 results in "incorrectly built binary"

Did you take an existing RedHat 8.0 box and upgrade
it to RedHat 9? Or did you do a fresh RedHat 9 install?

I use RedHat 9 for developement and we do not have any
problems with fresh installs.

Sounds like library incompatibilites. RedHat 8 had problems
with libraries and version. You might save your self time
by using a fresh redhat 9 install.

Ken Jones
inter7.com

On Friday 29 August 2003 4:43 am, Giuseppe Perricone wrote:
> Hi Cheers
>
> Hem.....
> if you read "all" my mail you can see that I "already" know what is the
> problem and I have "already" patch Qmail....
>
> My problem is "only"  with "qmailadmin" and "qadmin" and realy I search the
> patch also for qmailadmin and vqadmin, can you tee me where i can find it?
>
> Bye
>
> Giuseppe
>
>   ----- Original Message -----
>   From: Karl@fhills
>   To: Giuseppe Perricone
>   Sent: Friday, August 29, 2003 11:11 AM
>   Subject: Re: [vqadmin] The new glibc in RedHat 9 results in "incorrectly
> built binary"
>
>
>   Hi Guiseppe,
>
>   The C compiler changed under RH 9.0, you must apply a lot of patches for
> errno definitions in the various utilities and qmail to make it work, and
> recompile....
>
>   It is easy enough but a bit manual.
>
>   Cheers Karl
>     ----- Original Message -----
>     From: Giuseppe Perricone
>     To: [email protected]
>     Sent: Friday, August 29, 2003 5:07 PM
>     Subject: [vqadmin] The new glibc in RedHat 9 results in "incorrectly
> built binary"
>
>
>
>     Hi All,
>
>     I have installed
>
>     qmail-1.03
>     vpopmail-5.2.1
>     autorespond-2.0.2
>     ezmlm-0.53
>     qmailadmin-1.0.6
>     vqadmin-2.3.4
>
>     on RedHat 8.0.
>
>     All works fine but when I upgrade my server to RedHat 9.0 all go wrong.
>
>     The new glibc in RedHat 9 results in "incorrectly built binary" errors
> when attempting to run executables file in /cgi-bin/ of qmailadmin or
> vqadmin.
>
>     The error is due because /lib/tls/libc.so.6 does not have _res, errno
> and h_errno variables and cannot have them without slowing all programs
> down considerably.
>
>     I have already patch qmail-1.03, ucspi-tcp-0.88, daemontools-0.76 (
> with the respective patch qmail-1.03.errno.patch,
> ucspi-tcp-0.88.errno.patch and daemontools-0.76.errno.patch) then Qmail
> works correct. Is there a way to patch also qmailadmin or vqadmin?
>
>     thanks in advance
>
>     Giuseppe