Re: My K2000 isn't happy w/ SCSI2SD v6

"Jacob Vosmaer [email protected] [KurzList]" <[email protected]>
Newsgroups gmane.music.equipment.kurzweil
Message-ID <[email protected]> 
Hi Jeremy,

I'm attaching a screenshot of the scsi2sd-util6 settings. It's firmware 6.1..1. I think I'm using the defaults but I'm not sure. I did not remove the termination resistor in the K2000R. I have the internal terminator of the SCSI2SD enabled via software (as you can see in the screenshot). My K2000R OS is 3.87J.

Cheers, Jacob



> On 26 Nov 2018, at 01:27, [email protected] [KurzList] <[email protected]> wrote:
> 
> Thanks, Jacob.  That's encouraging.  Or, perhaps not as it suggests there might be an issue with my log mothballed K2000 rather then a SCSI2SD v6 incompatibility.  If I might throw a few questions at you:
> 
> 
> Did you remove the SCSI termination resistor in your K2000?  Did you use the default SCSI2SD parameters?  Could you share what version of the SCSI2SD firmware and K2000 OS you are using?
> 
> Thanks!
> Jeremy
> 
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.