Re: PC2 Power Supply Kycon Jack Socket Glued to Output Board?

"[email protected] [KurzList]" <[email protected]>
Newsgroups gmane.music.equipment.kurzweil
Message-ID <[email protected]> 
From the data sheet on the Mouser Electronics page https://au.mouser.com/datasheet/2/222/KPJX-4S-S-982273.pdf https://au.mouser.com/datasheet/2/222/KPJX-4S-S-982273.pdf it shows that the socket has a metal 'jacket' with tabs that pass through the circuit board to be soldered. 

 Together with the soldered power signal pins, plus it looks like more mechanical-only soldered pins, this is generally more than enough to hold it and there should not be any extra 'glue' or other bonding material.
 

 HTH
 

 Chris
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.