Re: PC2 Power Supply Kycon Jack Socket Glued to Output Board?

"[email protected] [KurzList]" <[email protected]> 07 Feb 2019 12:08:26 +0000

Newsgroups	gmane.music.equipment.kurzweil
Message-ID	<[email protected]>

I have the shielded,  un-shielded and panel versions of that Kycon Jack.
 

  I will try the de-solder gun and report back.

 Worst case I will install the Switchcraft panel jacks.
 

 Thank you!
 Sam in NJ

lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.