| Newsgroups |
gmane.music.equipment.midi-guitar |
| Message-ID |
<[email protected]> |
So that means that you probably have a preamp, or the casio needs it for
memory. Most probably the latter....
D.
On 2/1/2015 5:16 PM, [email protected] [midiguitar] wrote:
> Update!!!
>
> So today I was changing my strings and one of the ball-ends didn't
> want to fall out the back of the guitar, so I removed the plate that
> covers those holes - I had never removed it before. Expecting to see
> five springs there, I was quite surprised to see only three springs
> and a 9V battery where the other two springs should be. The black wire
> from the 9V is soldered onto the metal plate that the three springs
> are attached to, the red wire disappears into the guts. I'm about
> 99.9% sure this is connected to the extra toggle switch I have next to
> the SINGLE/HUMBUCKER toggle.
>
> Sent from my iPhone
>
> On May 4, 2014, at 23:53, David Messenger <[email protected]
> <mailto:[email protected]>> wrote:
>
>> Could be a Coil tap or Phase switch...
>>
>>
>> On 5/4/2014 7:25 PM, [email protected] wrote:
>>>
>>> Hello all,
>>>
>>>
>>> I've noticed while looking around at net images of Casio MG-500's
>>> that some appear to have two toggle switches in-between the volume
>>> and tone controls, though it appears that most show only one. The
>>> copy of the User Manual I have from this group only shows there
>>> being one toggle (humbucking/single). I'm wondering if there was a
>>> ever a slightly different version of the MG-500 that might have had
>>> a second toggle place next to the first, or if this is likely just
>>> the result of a common modification made by owners?
>>>
>>>
>>> Cheers,
>>>
>>> James
>>>
>>
>