Re: Re: PG-380 Humbucker Pickup

True. Thanks. 
-----Original Message-----
From: "JAMES HARRISON [email protected] [midiguitar]" <[email protected]>
Sender: [email protected]
Date: Sat, 31 Dec 2016 11:54:25 
To: <[email protected]>
Reply-To: [email protected]
Subject: [midiguitar] Re: PG-380 Humbucker Pickup

If all else fails you can figure it out with an ohm meter.

Luck,
James
.
.




>         Fri Dec 30, 2016 11:26 am (PST) . Posted by:
>
>
>       "John Abrams" fingerpickingjohnny
>       <mailto:[email protected]?subject=Re%3A%20PG-380%20Humbucker%20Pickup>
>
>
> I'm welding two (completely trashed) PG-380's that I had around for
> parts into a double-neck tapping guitar. I know these were very good
> guitars so I'm planning on re-using the humbuckers. The problem is the
> wiring seems to be non-standard. There are only 3 wires and a shield
> coming out of them. It's very hard to tell how these are wired since
> the pickups are potted. Even a look at my good PG-380 doesn't really
> give me a clue since everything seems to run through the circuit
> boards. The schematic doesn't help either - it's very incomplete to
> begin with.
>
> Does anyone know what brand these are - Ibanez? - and/or what the wiring
> scheme is?