Re: Re: PG-380 Humbucker Pickup

Thanks for the reply.  It's become a moot point.  After reading some 
very old reviews, it seems people didn't have a great deal good to say 
about those humbuckers so I bought a pair of Seymour Duncan JB's.


On 12/31/2016 8:54 AM, JAMES HARRISON [email protected] [midiguitar] 
wrote:
>
> If all else fails you can figure it out with an ohm meter.
>
> Luck,
> James
> .
> .
>
> > Fri Dec 30, 2016 11:26 am (PST) . Posted by:
> >
> >
> > "John Abrams" fingerpickingjohnny
> > 
> <mailto:[email protected]?subject=Re%3A%20PG-380%20Humbucker%20Pickup>
> >
> >
> > I'm welding two (completely trashed) PG-380's that I had around for
> > parts into a double-neck tapping guitar. I know these were very good
> > guitars so I'm planning on re-using the humbuckers. The problem is the
> > wiring seems to be non-standard. There are only 3 wires and a shield
> > coming out of them. It's very hard to tell how these are wired since
> > the pickups are potted. Even a look at my good PG-380 doesn't really
> > give me a clue since everything seems to run through the circuit
> > boards. The schematic doesn't help either - it's very incomplete to
> > begin with.
> >
> > Does anyone know what brand these are - Ibanez? - and/or what the wiring
> > scheme is?
>
> 



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus