Re: Static IP not Ping-able

Sean,

Using DHCP gave me the same results.

New firmware fixes the problem.

Without thinking too critically, I mistakenly
assumed that I needed IP connectivity to flash the firmware.

If you were to cut and paste from
firmware_update.pl to the site the fact that the bootloader will advertise it's MAC address you might prevent half-wits
like me from pestering you before they tried to upgrade the
firmware...Sorry to bother you.

Thanks. And again, great
product.

--rdr

----- Original Message -----

From:
Sean
Adams

To: [email protected]

Sent: Wednesday, February 06, 2002 9:16
AM

Subject: Re: [slimp3-users] Static IP not
Ping-able

Randy,

You say it doesn't work with a static
IP... does it work with DHCP?

Can you try flashing your firmware to
1.2?

Sean

On Wed, 6 Feb 2002, Randy Roy wrote:

>
Hello,
>
> I've managed to get into a state where I cannot even
ping my SliMP3. I presume I'm using V1.1 firmware (based on ship date)
and am using V1.8 of the server on a red hat 7.1 box.
>
> When I
cycle the power I can either bypass setup, or do setup. After each the
screen goes blank (no time) and the remote has no apparent effect. This
seems consistent with the following:
>
> Using a static IP
address, the device does not respond to a ping. (I do have link.)
Ethereal tells me I don't seem to be getting a reply to the ARP
request.
>
> This started happening around the time I tried the
server from 2002_02_05 and the browser UI from EudoraWeb on my visor.
I've since backed off to using server v1.8 on a wired LAN, but there is no
change in behavior.
>
> Any suggestions?
>
>
Regards,
> Randy
>

To
unsubscribe from this group, send an email
to:
[email protected]

Your
use of Yahoo! Groups is subject to the Yahoo! Terms of Service .

Yahoo! Groups Sponsor

ADVERTISEMENT
http://rd.yahoo.com/M=218512.1856015.3360178.1269402/D=egroupweb/S=1708298795:HM/A=928902/R=0/*http://ad.doubleclick.net/clk;3788030;6800959;r%3fhttp://www.verisign.com/cgi-bin/go.cgi?a=b229573240057000

To unsubscribe from this group, send an email to:

[email protected]

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service .