Re: Static IP not Ping-able

Randy,

You say it doesn't work with a static IP... does it work with DHCP?

Can you try flashing your firmware to 1.2?

Sean


On Wed, 6 Feb 2002, Randy Roy wrote:

> Hello,
>
> I've managed to get into a state where I cannot even ping my SliMP3.  I presume I'm using V1.1 firmware (based on ship date) and am using V1.8 of the server on a red hat 7.1 box.
>
> When I cycle the power I can either bypass setup, or do setup.  After each the screen goes blank (no time) and the remote has no apparent effect.  This seems consistent with the following:
>
> Using a static IP address, the device does not respond to a ping.  (I do have link.)  Ethereal tells me I don't seem to be getting a reply to the ARP request.
>
> This started happening around the time I tried the server from 2002_02_05 and the browser UI from EudoraWeb on my visor.  I've since backed off to using server v1.8 on a wired LAN, but there is no change in behavior.
>
> Any suggestions?
>
> Regards,
> Randy
>


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Tiny Wireless Camera under $80!
Order Now! FREE VCR Commander!
Click Here - Only 1 Day Left!
http://us.click.yahoo.com/nuyOHD/7.PDAA/yigFAA/rIp0lB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
[email protected]

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/