Static IP not Ping-able

Hello,

I've managed to get into a state where I cannot
even ping my SliMP3. I presume I'm using V1.1 firmware (based on ship date) and am using V1.8
of the server on a red hat 7.1 box.

When I cycle the power I can either bypass setup,
or do setup. After each the screen goes blank (no time) and the remote has
no apparent effect. This seems consistent with the following:

Using a static IP address, the device does not
respond to a ping. (I do have link.) Ethereal tells me I don't seem
to be getting a reply to the ARP request.

This started happening around the time I tried the
server from 2002_02_05 and the browser UI from EudoraWeb on my visor.
I've since backed off to using server v1.8 on a wired LAN, but there is no
change in behavior.

Any suggestions?

Regards,

Randy

To unsubscribe from this group, send an email to:

[email protected]

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service .