No additional data after upgrade

I just upgraded from 0.8.8f to 1.1.37.  I can still see old data, but no
new data is being added to the graphs.  When I visit a device's settings,
it shows the SNMP header and refreshing a query gives me the same number of
times as before.  I pulled up the poller command it if the crontab and ran
it manually, but there was no change.

I'm not sure what else to try.  Any suggestions would be greatly
appreciated, if you have them.


Jaime Kikpole
Director of Technology & Innovations
Cairo-Durham Central School District

-- 
This electronic message and any attachment(s) may contain confidential or 
legally privileged information protected by law from further disclosure and 
is intended only for the individual or entity identified above as the 
addressee. If you are not the addressee (or the employee or agency 
responsible to deliver it to the addressee), or if this message has been 
addressed to you in error, you are hereby notified that you may not copy, 
forward, disclose or use any part of this message or any attachment(s). 
Please notify the sender immediately by return email or telephone and 
permanently delete this message and attachment(s) from your system.