Re: No additional data after upgrade

Jaime,

Check out the `cacti.log` in the `log` directory.  It might give you 
some insight into what is going on.

The most common mistake on upgrade is either not copying the RRA files 
from your old installation or not updating the permissions on the RRA 
directory and files so that the user that runs the poller has read and 
write access.

If you still have an issue, email away, but please do include the OS 
Version and if you installed Cacti from the OS repos or from an official 
release file.

Tony

On 10/6/18 10:25 PM, Jaime Kikpole via cacti-user wrote:
> I just upgraded from 0.8.8f to 1.1.37.  I can still see old data, but no
> new data is being added to the graphs.  When I visit a device's settings,
> it shows the SNMP header and refreshing a query gives me the same number of
> times as before.  I pulled up the poller command it if the crontab and ran
> it manually, but there was no change.
> 
> I'm not sure what else to try.  Any suggestions would be greatly
> appreciated, if you have them.
> 
> 
> Jaime Kikpole
> Director of Technology & Innovations
> Cairo-Durham Central School District
>