Re: upgrading to 64bit counter

--- Ed Ravin <[email protected]> wrote:

> On Fri, Jan 25, 2008 at 09:21:08AM -0800, james bond
> wrote:
> > I am new to cricket and I have inhereted a cricket
> > installation with version 1.0.3.
> > I found out that when polling 10GigaBit Ethernet
> > interfaces, my chart clips off at about 100MB.
> > I have tried a number of methods to fix this
> problem
> > but I failed.
> > I figured that I need to upgrade to cricket
> version
> > 1.0.5 and SNMP_Session version 1.11 to allow for
> snmp
> > version 2.
> > Can any one provide a quick how_to to simply fix
> this
> > counter problem on the current installation. I
> need to
> > meet a dead line comming soon.
> > I am working on building a new server with a new
> > installation of cricket.
> > I am using Solaris 8 system with perl 5.6.0.
> 
> Have Cricket use an exec: source to call an external
> script that uses
> NetSNMP commands to fetch the values you want.  This
> assumes you have
> a NetSNMP build that supports SNMPv2, but that
> should be easy to get
> from sunfreeware.com.
> 

Hi,
Thanks a lot Ed for your reply.
I installed SNMPv2, and I have been trying to figure
out where to add my code into cricket. I have been
checking collector script but with no success to where
to add my stuff.
Could you provide me with more info on where to
proceed.

Thanks agian,



      ____________________________________________________________________________________
Be a better friend, newshound, and 
know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ 


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/