Re: Can't get named_sdb to load postgres modules?

On May 13, 2009, at 12:08 PM, Bradley Giesbrecht wrote:

> I believe Scott, Todd and I have used the srpms from here with on  
> rhel with success.
>
> http://people.redhat.com/atkac/bind/
>
> Might want to start there.
>
> The latest isc bind sources failed to build for me on rhel due to  
> rhel's libssl incompatibilities which I didn't feel like tracking  
> down.


Yes, those are the ones I had success with.  I am about to use those  
again today to set up the slave aamof.

Mike, my initial reply to you on the BIND mailing list included my  
notes on how the install went for the above url.  You may want to  
start clean, remove everything you have now, and use that as a guide,  
as it is known to work.  I have now installed based on those  
instructions 2 times, and will do my third a little later on today.
-- 
Scott * If you contact me off list replace talklists@ with scott@ *


------------------------------------------------------------------------------
The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your
production scanning environment may not be a perfect world - but thanks to
Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700
Series Scanner you'll get full speed at 300 dpi even with all image 
processing features enabled. http://p.sf.net/sfu/kodak-com