Re: adding/removing slave zones
"Kaulkwappe" <[email protected]>
| Newsgroups | gmane.network.dns.nsd.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Andreas, yes, it is! nsd-control addzone <zone name> <pattern name> nsd-control delzone <zone name> Kind Regards, Kaulkwappe ---------- Von: Andreas Schwarz <[email protected] > Gesendet: Dienstag, 28. Mai 2019 – 11:39 CEST +0200 An: [email protected] Betreff: [nsd-users] adding/removing slave zones Hi there, I have this setup, where I would like to add and remove a larger amount of slave zones rather regularly. What I currently do is this: I have a directory included in my nsd.conf. I put a file with a 'zone:' definition per slave zone in there. After I add or remove a zone, I use 'nsd-control reconfig' to reload NSD's configuration. However, telling NSD to reload it's entire configuration feels a bit rough. Therefore I am curious about, if there are better ways to do this. Best regards Andreas _______________________________________________ nsd-users mailing list [email protected] https://open.nlnetlabs.nl/mailman/listinfo/nsd-users