Re: ?==?utf-8?q? ?==?utf-8?q? addi ng/removing slave zones

@Kaulkwappe: I do this for primary zones. But I could not get it to work with secondary zones.
It would probably work, if all my secondary zones had the same primary nameservers, which I could then configure in a pattern. 
Unfortunately, the zones use a varying bunch of nameservers. Therefore from my point of view, I would end up configuring a pattern for each zone. To reload the pattern I would again have to use 'reconfig' option.

@Anand: no it is not causing any problems so far. It only feels rough compared to primary zones with the 'nsd-control addzone' or 'nsd-control reload' commands.
And if something feels rough, I usually asume that I am working against a system and that there is a better way.



Thank you for your feedback.

_______________________________________________
nsd-users mailing list
[email protected]
https://open.nlnetlabs.nl/mailman/listinfo/nsd-users