Re: adding/removing slave zones

On 29/05/2019 18:59, Andreas Schwarz wrote:

Hi Andreas,

> @Anand: no it is not causing any problems so far. It only feels rough compared to primary zones with the 'nsd-control addzone' or 'nsd-control reload' commands.
> And if something feels rough, I usually asume that I am working against a system and that there is a better way.

Given your use-case, I can't think of a better way of doing this. I
think your solution is just fine. Nothing rough or inelegant about it.
We do something similar for one class of zones we manage, except that we
generate a single file with all the zones in it, and then reconfig nsd.

Regards,
Anand