Re: Re: Compiling kernel modules (was Re: 2 questions)

On Wed, Nov 12, 2003 at 04:33:33PM -0500, Charlie Brady wrote:
> Spec file is attached. That should allow you to build your own binary 
> RPMs. Use "rpmbuild -bb --target=xxx powerswitch.spec".

Excellent.  One thing, though: is anything on an E-smith system likely
to unload that module?  I'm considering adding a small amount of fluff
to the rpm and a cron job to check and reload if necessary will probably
go in to assuage my paranoia (the other fluff being server-manager
options to a) enable or disable the module and b) to enable/disable a
double beep when the boot sequence has finished or the shutdown sequence
is beginning.  Come to think of it, I'll just put those into a
separate rpm and have it require this powerswitch one.

-- 
Bruce

Remember you're a Womble.

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)
Comment: http://website.lineone.net/~brichardson/pubkey/gpg.txt

iD8DBQE/ssgOTUoovyBEcVQRAnDzAJ4mTl5PflbjdE+5G8wnWHTL9Kdp3QCaA3Jc
zlo4cOD9lzvo3paiBmfafyI=
=dRC2
-----END PGP SIGNATURE-----