Re: Notice to Package SMEServer-5.6*.rpm

To: All upgraders

Further to my earlier post I have now completed a script which will
install the rpm's and then picks the required mppe module and installs it.
I have left a beta copy for comment/debugging at :
www.lygonit.com.au/mitel/upgrade56.pl
The final install location will be /opt/SMEServer-5.6_Upgrade5/ with the
script to run from tmp.

As the nut rpms seem to be special case I have omitted them. (unless
requested )

 Regards

 Stewart Evans
 Network Technician
 Lygon IT
 [email protected]
 (618) 8211 8522

p.s. to Darrell May - would you have a copy of the older .spec file for the
5.1.2 update please?



----- Original Message ----- 
From: "Stewart Evans" <[email protected]>
To: <[email protected]>
Sent: Tuesday, November 11, 2003 5:26 PM
Subject: Re: [e-smith-devinfo] Notice to Package SMEServer-5.6*.rpm


> To : All upgraders
>
> As I believe the reason for no Update RPM is the problems linked with mppe
> architecture setup I have sat down and written a small "selector" routine.
>
> Before one goes tearing off and bundling up Update5 I though I had better
> check
> if some kind soul had beaten me to it.
>
> The format I have penciled in would have 2 directories "rpms and mppe"
with
> an installer
> that would pick one of the 4. Based on the older 5.1.2Update3 by Darrell
May
>
> Regards
>
> Stewart Evans
> Network Technician
> Lygon IT
> [email protected]
> (618) 8211 8522
>
> ----- Original Message ----- 
> From: "Rob Wellesley" <[email protected]>
> To: "SME Developers List" <[email protected]>
> Sent: Monday, October 20, 2003 11:01 AM
> Subject: [e-smith-devinfo] SMEServer-5.6*.rpm
>
>
> > Hi there
> >
> > Finally got some time to start updating 5.6 server's with the OpenSSH
and
> > ProFTP updates and noticed no SMEServer-5.6Update*.rpm on the mirrors -
is
> > this right?
> >
> >
> > Kind Regards
> >
> > Rob Wellesley
> >
> > Network Support Division
> > Winux Limited
> >
> > Ph:  03 9817993
> > Fax: 03 9800919
> >
> >
> >
> >
> > --
> > Please report bugs to [email protected]
> > Please mail [email protected] (only) to discuss security issues
> > Support for registered customers and partners to [email protected]
> > To unsubscribe, e-mail: [email protected]
> > For additional commands, e-mail: [email protected]
> > Searchable archive at
> http://www.mail-archive.com/devinfo%40lists.e-smith.org
> >
> >
>


--
Please report bugs to [email protected]
Please mail [email protected] (only) to discuss security issues
Support for registered customers and partners to [email protected]
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Searchable archive at http://www.mail-archive.com/devinfo%40lists.e-smith.org