RE: 0.99 ESP protocol preferences

Ok, you might have seen this question coming :)

I got it installed with the new features for ESP decrypt, but I am not sure
why I can't decrypt the capture.  Based on the information here:

http://wiki.ethereal.com/ESP_Preferences

I essentially just set my SPI and addresses to match any:

IPv4|*|*|*

I have my encryption and authentication algorithms set, and have the correct
encryption key.  However, one thing to note, I do NOT see 'Attempt to Check
ESP Authetication' check box.  I am not sure if this matters, but I only
have the two check box options above it (Null and ESP decode/decrypt)

I still see just ESP in the capture.  What am I missing?



-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Joerg Mayer
Sent: Monday, June 12, 2006 10:57 AM
To: Ethereal user support
Subject: Re: [Ethereal-users] 0.99 ESP protocol preferences

On Sun, Jun 11, 2006 at 05:42:11PM +0200, Joerg Mayer wrote:
> This is, how it looks on my system (untested):
> 
> CFLAGS="-O3 -DHAVE_LIBCRYPT" ./configure --with-extra-gcc-checks .......
> 
> I think you need the CFLAGS="-DHAVE_LIBCRYPT" 

OK, tested, works for me. Please let me know about your results.

 Ciao
    Joerg
-- 
Joerg Mayer                                           <[email protected]>
We are stuck with technology when what we really want is just stuff that
works. Some say that should read Microsoft instead of technology.
_______________________________________________
Ethereal-users mailing list
[email protected]
http://www.ethereal.com/mailman/listinfo/ethereal-users