RE: 0.99 ESP protocol preferences

Ok, I see a problem, it appears I am limited to what I can use as an
encryption/algorithm option.

I am using ESP/MD5/HMAC-128 for my authenticaton, and 3DES-168 for
encryption on IPSec.  

ESP/HMAC-128 and 3DES-168 for ISAKMP.

I see this on the console when configuring my ESP protocol for 3DES-CBC:

<ESP Preferences> Error in Encryption Algorithm 3DES-CBC : Bad Keylen (64
Bits)

Obviously my options are not matching up to what I have on my VPN tunnel.
Not sure what to do here.  I really don't want to back off my tunnel to see
captures.  AES is an option I could move to, but it is not supported in my
hardware currently.  Any other ideas?? Suggestions?

Thanks again for your time and input!

-Chris



-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Chris Flory
Sent: Monday, June 12, 2006 3:32 PM
To: 'Ethereal user support'
Subject: RE: [Ethereal-users] 0.99 ESP protocol preferences

Ok, you might have seen this question coming :)

I got it installed with the new features for ESP decrypt, but I am not sure
why I can't decrypt the capture.  Based on the information here:

http://wiki.ethereal.com/ESP_Preferences

I essentially just set my SPI and addresses to match any:

IPv4|*|*|*

I have my encryption and authentication algorithms set, and have the correct
encryption key.  However, one thing to note, I do NOT see 'Attempt to Check
ESP Authetication' check box.  I am not sure if this matters, but I only
have the two check box options above it (Null and ESP decode/decrypt)

I still see just ESP in the capture.  What am I missing?



-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Joerg Mayer
Sent: Monday, June 12, 2006 10:57 AM
To: Ethereal user support
Subject: Re: [Ethereal-users] 0.99 ESP protocol preferences

On Sun, Jun 11, 2006 at 05:42:11PM +0200, Joerg Mayer wrote:
> This is, how it looks on my system (untested):
> 
> CFLAGS="-O3 -DHAVE_LIBCRYPT" ./configure --with-extra-gcc-checks .......
> 
> I think you need the CFLAGS="-DHAVE_LIBCRYPT" 

OK, tested, works for me. Please let me know about your results.

 Ciao
    Joerg
-- 
Joerg Mayer                                           <[email protected]>
We are stuck with technology when what we really want is just stuff that
works. Some say that should read Microsoft instead of technology.
_______________________________________________
Ethereal-users mailing list
[email protected]
http://www.ethereal.com/mailman/listinfo/ethereal-users

_______________________________________________
Ethereal-users mailing list
[email protected]
http://www.ethereal.com/mailman/listinfo/ethereal-users