Re: How does pluto read ipsec.conf options?

ipsec.conf is read by the _confread script which in turn
calls the auto script which finally assembles whack command lines.
whack then communicates via a socket interface with pluto
(in freeswan-1.99 you find the receiving part in kernel_comm.c,
  in freeswan-2.00 it is in rcv_whack.c).

Regards

Andreas

The the Roberto Barcellona wrote:
> Hi.  
>   
> I need to know where in the code the pluto daemon reads the settings of 
> connection in the ipsec.conf. 
> I have read the code but seems that pluto have already a list of connections 
> internally. I don't find where while pluto is starting, it reads the 
> ipsec.conf. 
>  
> Thanks in advance.    
> 
> 
> ---------------------------------------------
> This message was sent using Endymion MailMan.
> http://www.endymion.com/products/mailman/
> 
> 
> _______________________________________________
> Design mailing list
> [email protected]
> http://lists.freeswan.org/mailman/listinfo/design


-- 
=======================================================================
Andreas Steffen                   e-mail: [email protected]
strongSec GmbH                    home:   http://www.strongsec.com
Alter Zürichweg 20                phone:  +41 1 730 80 64
CH-8952 Schlieren (Switzerland)   fax:    +41 1 730 80 65
==========================================[strong internet security]===