RE: configuration of addresses on ipsec0.

hi
iam using freeswan-1.91-v02 .and not the version with U-1.99 and K-1.91
so i think i should be using _startklips from the newer version.





Thursday, 10 April 2003 2:33 PM
To: "Kaustubh Kumbhalkar" <[email protected]>,
<[email protected]>, <[email protected]>
cc:
From: "Gessler Gerhard" <[email protected]>
Subject: RE: [Users] configuration of addresses on ipsec0.



Hi,

as I know that you are dealing quite heavily with IPv6, I assume that the
question is IPv6 related, even if not explicitly stated.

What version of IPv6-enabled FreeSWAN do you use?
I know we had this effect in older verions, but if I am not mistaken, we
changed that in our later versions.

Best Regards,

 Gerhard

--------------------------------------------
Gerhard Ge=DFler

Communication Networks, IABG mbH
Einsteinstr. 20
85521 Ottobrunn, Germany

Telefon: +49 89 6088 - 2021
Fax: +49 89 6088 - 2845

E-Mail: [email protected]

  > -----Original Message-----
  > From: Kaustubh Kumbhalkar
  > [mailto:[email protected]]
  > Sent: Wednesday, April 09, 2003 7:03 AM
  > To: [email protected]; [email protected]
  > Subject: [Users] configuration of addresses on ipsec0.
  >
  >
  > hi
  > i am facing a problem w.r.t configuration of addresses on
  > ipsec0 dev. at the time i  give the command ipsec setup
  > start, there are multiple addresses configured on eth0
  > device. but pluto configures only one address on ipsec0
  > device which is the first address in the list. all the
  > addresses are valid globally routable unicast addresses.
  > another problem  is that when router advertisements are
  > recieved it configures the any new prefixes over ipsec0 and
  > not on eth0. what could be happening ?
  >
  > help pls
  >
  > kausty
  >
  > _______________________________________________
  > Users mailing list
  > [email protected]
  >   > http://lists.freeswan.org/mailman/listinfo/users
  >