(racoon 809) Address range in spdadd

Hello,

I wanted to use source/destination address ranges in spdadd but got
errors. Here's the command I used:

spdadd 10.10.16.13-10.10.16.14 10.10.26.13-10.10.26.24 udp -P out ipsec
esp/tunnel/10.1.14.3-10.1.24.3/require

The error message said:

Temporary failure in name resolution at [out ipsec
esp/tunnel/10.1.14.3-10.1.24.3/require]

When I used option -n I got a different error message:

Name or service not known at [out ipsec
esp/tunnel/10.1.14.3-10.1.24.3/require]

Everything was all right when I used single addresses instaed of a range
of address, but then I had to write 4 spdadd lines instead of one. Does
anyone have any idea that may help?

Many thanks,

T.Nguyen
Lockheed Martin ISS,
Clarksburg, Maryland, USA