(racoon 810) Re: Address range in spdadd

Hi 
your problem is in the syntax. The valid syntax is 


spdadd 10.10.16.13-10.10.16.14 10.10.26.13-10.10.26.24 udp -P out ipsec 
esp/tunnel/10.1.14.3-10.1.24.3//require 

i.e there will be two slashes before require.

Rgds
Amit Kumar Ray
Software Engineer
Hughes Software System
Gurgaon Facility

***********************  HSS-Unclassified   ***********************

"Please note:The email domain of Hughes Software Systems Ltd. has been changed to "hssworld.com" from hss.hns.com"

"DISCLAIMER: This message is proprietary to Hughes Software Systems Limited (HSS) and is intended 
solely for the use of the individual to whom it is addressed. It may contain  privileged or 
confidential information and should not be circulated or used for any purpose other than for 
what it is intended. If you have received this message in error, please notify the originator 
immediately. If you are not the intended recipient, you are notified that you are strictly 
prohibited from using, copying, altering, or disclosing the contents of this message. HSS 
accepts no responsibility for loss or damage arising from the use of the information transmitted 
by this email including damage from virus."