RE: bopm refusing to start

Here are the two forms I had for the o:line:

O:*@*:xxxxxxx:defiant:FNOARDZWHTsfkceazvHq:1

O:[email protected]:xxxxxxx:defiant:FNOARDZWHTsfkceazvHq:1

I have the latter o:line duplicated across all my servers, and it is showing
in a /stats o.

So, any suggestions as to why the oper command fails and tells me there are
no o:lines for my host?

-----Original Message-----
From: Sys Admin [mailto:[email protected]]
Sent: Wednesday, March 17, 2004 8:22 PM
To: Leesa
Subject: Re: [bopm] bopm refusing to start


Hmm I have never used Unreal before but I would try the debug mode and watch
carefully for errors when it trys for the ops.
It will list alot of stuff so you will have to sort through it but you
should be able to get a idea of what is going on.
Is the nick you are using registered with the services ?
>From what you have said it sounds like it.
Can you paste the O line here and **** out the password ?
Also pasting the full error would also be helpful.
If you wish some real time Asst you can log onto my server and enter the
room #Land-of-Ahz
you will need to you my IP address as my fine Host can't get a A record
right on there DNS server right now
So that would be : 24.19.203.69
Let me know if you have any problems.

I am here to serve.

Ahz
~~~
www.Land-of-Ahz.com
IRC.Land-of-Ahz.com
----- Original Message -----
From: Leesa
To: Sys Admin
Sent: Wednesday, March 17, 2004 6:06 PM
Subject: RE: [bopm] bopm refusing to start


Thanks, I found the problem and got it started.  Now, I have another
problem.

We are running hybrids of both Unreal3.1.5.1 and Epona services.  I can get
the bot to ID to nickserv properly, but it is not executing a successful
oper command.

It is claiming no o-lines for the host.  I had the o:line coded with *@* to
begin with, then I coded it with the bot's specific mask, and I keep getting
the same message.

Suggestions?

-----Original Message-----
From: Sys Admin [mailto:[email protected]]
Sent: Wednesday, March 17, 2004 7:30 PM
To: Leesa
Subject: Re: [bopm] bopm refusing to start


I would try running Bopm in debug mode like this --> ./bopm -ddd
and see if you get any errors.
The debug mode is not much use but can help with problems like these.
What Distro did you install it on ?
What version of IRC are you running ?

Ahz
~~~
www.Land-of-Ahz.com
IRC.Land-of-Ahz.com
----- Original Message -----
From: Leesa
To: [email protected]
Sent: Wednesday, March 17, 2004 4:54 PM
Subject: [bopm] bopm refusing to start


This question has likely been asked a thousand times already...consider this
time 1001.

I followed every direction available in setting up bopm.  I go into the /bin
subdirectory of bopm and type ./bopm

Nothing happens.

Anyone have a clue? Thanks.