Re: target line with 2 different-typed OIDs
Daniel McDonald <[email protected]>
| Newsgroups | gmane.network.mrtg.user |
|---|---|
| Message-ID | <CB4FE9CA.47171%[email protected]> |
On 2/2/12 6:19 AM, "Yannis Nikolopoulos" <[email protected]> wrote: > Hi, > > I'm in a situation where I need to graph 2 OIDs of different type, a > counter and a gauge. I know I can do it by using RRDTool > (rrdcreate,rrdupdate and rrdgraph) and I know I can define two separate > targets in an MRTG conf file and then use routers2 to produce the > combined graph. Yes, two targets with noo or noi combined into one combined routers2 graph is the best way to go about it. > > The question is: can I use a single target definition in an MRTG conf > file in order to graph to OIDs of different type? No. -- Daniel J McDonald, CCIE # 2495, CISSP # 78281