Re: target line with 2 different-typed OIDs

Hey Yannis,

I asked the exact same question to Steve Shipway, the developer of 
routers2 on his forum at steveshipway.org...
The link to my question, that should give you your answer is here --> How 
to Display Graphs that Have More than One Type of Data?

Hope that helps...

Thanks,
Matt







From:   Yannis Nikolopoulos <[email protected]>
To:     <[email protected]>
Date:   02/02/2012 07:20 AM
Subject:        [mrtg] target line with 2 different-typed OIDs
Sent by:        <[email protected]>



Hi,

I'm in a situation where I need to graph 2 OIDs of different type, a 
counter and a gauge. I know I can do it by using RRDTool 
(rrdcreate,rrdupdate and rrdgraph) and I know I can define two separate 
targets in an MRTG conf file and then use routers2 to produce the 
combined graph.

The question is: can I use a single target definition in an MRTG conf 
file in order to graph to OIDs of different type?

e.g.

Target[xxx]:OID1&OID2:community@device
Options[xxx]: Growright,nopercent,???

cheers

_______________________________________________
mrtg mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg

_______________________________________________
mrtg mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg