Re:[myrinet] Re: RE:About gm configuration!

Hi:
   Thank you very much! -:)
   As you said, I checked my network connection.The switch is not plugged in and operating.Now I plugged the switch,and gm works.

Best regards.
   

>"Áõ¸è" wrote:
>
>>    But it is sure your check-up list is fine.
>>    The OS in the node running the mapper and gm_allsize are linux6.2,and the other nodes are linux7 which
>> have no GM.But if I disconnect other nodes from the switch and only connnect the switch to the node running the
>> mapper.The problem is the same.Anything is wrong.
>
>> >Are you sure the node running the mapper has a myrinet card ? the GM
>> >module is loaded on this node ? the cable is connected to the card ? the
>> >other end to the switch ?
>
>Does the switch has power ? (this one took me 2 hours the other
>day to figure out. On the old 8 ports switches, there is no fan to
>make noise when it's running :-) )
>Which type of cards do you have (which Lanai version) ? Which type
>of cable ?
>Have you tried with another machine and/or another card ?
>
>-- 
>Patrick Geoffray
>
>---------------------------------------------------------------
>|      Myricom Inc       |  University of Tennessee - CS Dept |
>| 325 N Santa Anita Ave. |   Suite 203, 1122 Volunteer Blvd.  |
>|   Arcadia, CA 91006    |      Knoxville, TN 37996-3450      |
>|     (626) 821-5555     |      Tel/Fax : (865) 974-0482      |
>---------------------------------------------------------------

_____________________________________________
263Commail£¬ÆóÒµµÄµç×ÓÓʼþר¼Ò http://mail.263.net