Re: [myrinet] RE:About gm configuration!

"Áõ¸è" wrote:

>    But it is sure your check-up list is fine.
>    The OS in the node running the mapper and gm_allsize are linux6.2,and the other nodes are linux7 which
> have no GM.But if I disconnect other nodes from the switch and only connnect the switch to the node running the
> mapper.The problem is the same.Anything is wrong.

> >Are you sure the node running the mapper has a myrinet card ? the GM
> >module is loaded on this node ? the cable is connected to the card ? the
> >other end to the switch ?

Does the switch has power ? (this one took me 2 hours the other
day to figure out. On the old 8 ports switches, there is no fan to
make noise when it's running :-) )
Which type of cards do you have (which Lanai version) ? Which type
of cable ?
Have you tried with another machine and/or another card ?

-- 
Patrick Geoffray

---------------------------------------------------------------
|      Myricom Inc       |  University of Tennessee - CS Dept |
| 325 N Santa Anita Ave. |   Suite 203, 1122 Volunteer Blvd.  |
|   Arcadia, CA 91006    |      Knoxville, TN 37996-3450      |
|     (626) 821-5555     |      Tel/Fax : (865) 974-0482      |
---------------------------------------------------------------